Professional Profile
More than 22 years of experience in the power industry, mostly in protection and control design.
Selected Experience
Protection and control engineering
Engineering practice | Albuquerque, NM (remote) | August 2026 to present
QA/QC of a one-line diagram for a client, review of an RFI on a potential project, and review of client standards.
Subject matter expert, protection and controls
Gridworks | Albuquerque, NM | March 2024 to October 2025
Reviewed relay one-line, three-line and elementary diagrams and relay rack design, wiring and interconnection diagrams at 30%, 60%, 90% and IFC. Implemented a P&C design checklist and helped develop company standards for scope of work and design flow. Used ETAP for power flow, short-circuit and protection coordination studies. Reviewed BESS, PV, SCADA and substation electrical designs submitted by contractors, and electrical studies.
Independent contractor
Sverdrup Engineering Services | Tucson, AZ (part-time remote) | August 2023 to November 2023
Medium-voltage switchgear design: relay one-line, three-line, elementary and interconnection diagrams; SEL relays for bus differential and overcurrent protection; 15 kV, 5 kV and 480 V NEMA 3R switchgear. All drafting in AutoCAD.
Protection and control design
Sargent & Lundy | Chicago, IL (remote) | 2022 to 2023
Breaker replacement, transformer LTC controller upgrades (Beckwith M-2001D) and RTU/SCADA upgrades at voltages up to 345 kV: schematics, three-line diagrams, breaker control circuits, AC and DC panels, bus and transformer differential, feeder overcurrent and line or distance protection, relay panel and interconnection wiring, RTU/SCADA points lists and cable and conduit schedules. Drafting in MicroStation.
Protection and control design and QA/QC
Manpower, Albuquerque, NM, 2019 to 2022 | Advanced Professional Engineering, Las Vegas, NV, 2018 to 2019
Breaker, transformer and RTU/SCADA upgrades and capacitor bank replacements at voltages up to 345 kV: schematic, elementary and three-line diagrams, breaker control circuits, AC and DC panels, bus and transformer differential, feeder overcurrent and line or distance protection, cabinet and interconnection wiring, SCADA points lists and cable scheduling. QA/QC of P&C projects before IFC release. Isolation prints for powering down circuit breakers. Drafting in AutoCAD.
Protection and control design and QA/QC
TRC Inc., Albuquerque, NM | 2007 to 2018
Design at voltages up to 345 kV: relay one-line, elementary and three-line diagrams, breaker control circuits, AC and DC panels, bus and transformer differential, feeder overcurrent and line or distance protection, cabinet and interconnection wiring, RTU upgrades and cable scheduling. QA/QC of P&C projects before IFC release. Drafting in AutoCAD or MicroStation, by client preference.
Graduate assistant
New Mexico State University | 2005 to 2006
Power flow, short-circuit and stability study of the campus electrical network in EDSA (over 230 transformers, switches, fuses and cables), power quality on a 4.65 MW gas-turbine generator, overcurrent relay settings and fuse coordination.
Electronics engineer
Syndetix Inc., Las Cruces, NM | 2000 to 2004
Radiation hardness testing of electronic components at White Sands Missile Range: C test procedures and test circuits using small digital relays.

